Losi LOSB0221 Getting Started Manuel d'utilisateur télécharger pdf

Page 1

GETTING STARTED

Step 1

Plug the AC charger into the proper wall receptacle

(110V). Plug the battery pack into the charger and

let it charge for 3 hours for the ﬁrst time. After

running, or when the Mini-Late Model slows

noticeably, recharge the battery pack for 5 to 6

hours for a full charge.

Step 2

Remove the transmitter battery cover by sliding the

cover from left to right. Install four (4) AA batteries

into the battery holder. Pay close attention to the

correct direction of the positive (+) and negative (-)

ends as marked in the tray. Once all 4 batteries have

been installed, reinstall the battery cover by sliding it

on from right to left.

Step 3

Once the battery is charged, remove the body clip

from the front battery hold-down and remove the

battery strap (ﬁg. 1).

Install the charged battery pack into the chassis as

shown (ﬁg.2). Ensure that the battery is laying ﬂat on

the chassis.

NOTE:

Before you start running your new Mini-Late Model, it is absolutely

necessary that you read through all of the operating instructions to prevent

unnecessary damage and get the maximum enjoyment from your vehicle.

Reinstall the battery strap and body clip. Plug

the battery pack into the ESC (ﬁg. 3).

1 2

Page 1GETTING STARTEDStep 1Plug the AC charger into the proper wall receptacle (110V). Plug the battery pack into the charger and let it charge for 3

Page 2

13117BPage 2Step 5Always turn on the transmitter ﬁrst by sliding the switch on the left side of the wheel from left to right. The small red and gree

Pas de commentaire

Losi LOSB0221 Getting Started Manuel d'utilisateur